Lesson 4/Learning Event 2
FIGURE 32.
DA FORM 2765 (REQUEST FOR ISSUE OR TURN-IN)
PREPUNCHED/PREPRINTED
Use of Forms to Request Repair Parts. The following forms will be used to
request repair parts: (The DX and QSS requests will be addressed later in
this learning event, under Types of Stockage.)
1.
The DA Form 2765 (Request for Issue or Turn-In) Prepunched/Preprinted
(Figure 32) is normally available for each item in the PLL. In the manual
system, these should be filed behind each corresponding DA Form 3318.
Supervisors should always check to make sure that prepunched/preprinted DA
Forms 2765 are being used if they are available.
The use of these cards
lessens the possibility of errors considerably and makes requests easier and
faster to prepare
117
Previous Page
