11. In  the  TO,  where  are  water
distribution lines normally placed?
a. cross-country
what minimum diameter pipe will you
b. adjacent to roadways
select (only 2-, 3-, 4-, and 5-inch
c. shortest route
pipe are available) for a flow rate
d. adjacent to streams
of  100  gallons  per  minute  and  a
maximum  headloss  of  10  feet  of
12. You  are  installing  a  water
water in its 500-foot length?
distribution system whose pipe has
a. 2
c. 4
a maximum safe pressure rating of
b. 3
d. 5
120 pounds per square inch.
What
is the maximum elevation difference
17. What is the smallest pipe size
in feet that you can have between
(in inches) that can be used for a
the tank and the lowest point in
flow of 70 gallons per minute, a
the system?
coefficent of friction (c) of 150,
a. 248
c. 277
and a headloss of 5 feet of water
b. 263
d. 289
in its 1,000-foot length?
a. 3
c. 5
13. For population of 1,850 men,
b. 4
d. 6
what is the total peak water demand
in
gallons
per
minute
for
a
18. Figure
17
shows
a
water
facility containing 10 outlets and
distribution  system.
The  peak
21 shower heads?
demands for each of the buildings
a. 26
c. 39
are shown below.
b. 34
d. 43
14. What is the allowable headloss
in feet of water from the storage
tank to the service connection if
the tank elevation is 265 feet, the
service connection elevation is 141
feet, and 25 psi is required at the
connection?
a. 41
c. 59
b. 53
d. 66
15. What  will  be  the  flow  in
What is the peak flow in gallons
gallons per minute for a section of
per  minute  the  line  from  C  to  D
7-inch pipe if the headloss is 5
must be able to carry?
feet  of  water  in  its  1,000  foot
a. 200
c. 230
length
and
the
coefficient
of
b. 225
d. 255
a. 210
c. 270
b. 240
d. 300
Figure 17.
For use with exercise 18.
3-25